700 T3 T5 T6 50° T4 T1 T2 W3 W2 W1

Q: The chain binder is used to secure loads of logs, lumber, pipe, and the like. If the tension 1 is…

A:

Q: 2. Determine the force in each member of the truss and state if the members are in tension…

A:

Q: 05. The homogeneous 600-lb plate is suspended from three cables. Determine the tension in each…

A:

Q: Determine the spring constant k4 (N/m) if the extension of the whole system is 1.04 m when a force…

A:

Q: Q1- if the 5 kg block is suspended from the pulley B and the sag of the cord is d=0.15m determine…

A:

Q: Q.2.ch.3: Determine the magnitude and direction of F so that the particle is in equilibrium. A kN D°…

A:

Q: In the absence of body forces, does the following stress tensor satisfy the equations of…

A: No it does not satisfy the equilibrium condition

Q: The 60 kg block is supported by two springs having the stiffness shown. Determine the stretch of…

A:

Q: The breaking strength of the cable FG that supports the portable camping stool is 400 lb. Determine…

A: FBD of the entire structure  ∑ME=0W(12 in)-Ay(18 in)=0Ay=23W

Q: Q1- if the 5 kg block is suspended from the pulley B and the sag of the cord is d=0.15m determine…

A:

Q: 6. 2) The uniform slender 14-kg bar of length /= 3.2 m rests on smooth surfaces but starts to slide…

A: To find: The normal force at point A. Given: The mass of the slender bar is m=14 kg. The length of…

Q: Q10a Assuming the pulley system below is weightless and frictionless pulley, determine reaction…

A: As it is seen from the diagram that the The Pulley and string system is attached with the ceiling at…

Q: Q1: The chain binder is used to secure loads of logs, lumber, pipe, and the like. If the tension T…

A: Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the following…

Q: The hoist supports an engine of weight W in kg. Determine the force the load creates in member DB…

A: Data given - X=2 m ; L=3 m ; W= 123 kg To determine - force the load creates in member DB and in…

Q: Q9 The pulley system below is in static equilibrium. If the load W, is 500 N. Determine value of the…

A: Given Data W1=500 N

Q: Q1: The five forces shown are in equilibrium. Compute the values of P and F. 20 kN 60° 30 15 kN 45°…

A: Component of Force F and P in x and y direction.and Draw the component of 40KN in x and y direction.…

Q: Determine the value of P and F to maintain equilibrium of the forces. 105° 60 300 lb Determine P 45°…

A:

Q: Q1: Determine the forces in cables AC and AB needed to hold the 20-kg ball D in equilibrium. Take F…

A:

Q: Determine the N.F. of the D.O.F. Springs - Mass Systems as shown in Figures belov k M k 2M X2 k 3M…

A: INTRODUCTION : The degree of freedom is defined as the smallest number of coordinates required to…

Q: Four forces are exerted on the eyebolt as shown. If the net effect on the bolt is a direct pull of…

A:

Q: The forces F1 = 500 N, F2 = 400 N, and F3 %3D = 700 N all of which act on point A of the bracket,…

A: Given:              F1 = 500 NF2 = 400 NF3 = 700 N             Angle which force F1 makes with the…

Q: Determine the N.F. of the D.O.F. Springs - Mass Systems as shown in Figures below? k M1 k M2 X2 k M3…

A:

Q: Four forces are exerted on the eyebolt as shown. If the net effect on the bolt is a direct pull of…

A: Given dataFour Forces are exerted on eyeboltF1=380 lbF2=205 lbF3=420 lb ϕ=29°Pulling Force…

Q: A four-link mechanism is subjected to the following external forces determine the shaft torque T2 on…

A: Link 3 and 4 are both two force member  Therefore f4 can be along BC and f43 along  oc=A3×F43 is to…

Q: 3. Determine the largest force P for which the 18 kg uniform bar remains in equilibrium. M= 0. 20…

A:

Q: The 100 kg block is supported by two springs having the stiffness shown. Determine the stretch of…

A:

Q: Determine the forces (in Newtons) in cables AC and AB needed to hold the 28.9-kg ball D in…

A: To determine the forces in cable AC and AB.

Q: Determine the magnitude of the force which member CD exerts on the pin at C. A 125 ° D B 0.59 m 0.46…

A:

Q: Four forces are exerted on the eyebolt as shown. If the net effect on the bolt is a direct pull of…

A: Calculated the necessary values of T and theta.

Q: 3. If the three forces, F1, F2, and F3, are in static equilibrium then not only do the three forces…

A:

Q: - 24 in.- D P 10 in. B C y

A:

Q: Determine the unstretched length of spring AC if a force P = 100 Ib causes the angle 0= 52° for…

A:

Q: The spring has a stiffness of k = 800 N/m and an unstretched length of 200 mm. Determine the force…

A:

Q: The homogeneous 600-lb plate is suspended from three cables. Determine the tension in each cable.…

A: Given: Weight of the plate is 600 lb.

Q: Sind the weight of the pully te Kep the system in equilibrium. 65N 60 3.

A:

Q: Assuming the pulley system below is weightless and frictionless, determine the distance (d2) when a…

A:

Q: F1=100N Let F₁ = [F1] N and let F2 = 350 N. g) Determine the magnitude FA of the force at pin A. h)…

A:

Q: Determine the magnitude of the pin force at A. Assume W = 795 lb, a = 2.9 ft, b = 2.2 ft, r = 7 in.…

A:

Q: The ring at B is supported in equilibrium by spring AB, a cable running through the frictionless…

A: Given Data: The value of forces F1=340 N and F2=200 N. The unstretched length of the spring is…

Q: The spring clamp of Fig. block Fagainst the floor. The force in the spring is F = k(e – lo), where e…

A: k=240 lb/ft ;l0=Unstretched lenght of the spring =3 in ;l=stretched lenght of the spring =8 in ;…

Q: Determine the magnitude of the pin force at A. Assume W = 750 lb, a = 2.7 ft, b = 2.0 ft, r = 6 in.…

A:

Q: 12. Determine whether the 9 Kg block shown is in equilibrium, find the magnitude and direction of…

A: Given data  mass of block = 9 kg P = 60 N θ = 15o μs = 0.30 μk = 0.25 To determine magnitude and…

Q: A/The spring has a stiffness of k= 600 N/m and an unstretched length of 200 mm. Determine the force…

A:

Q: F1 926N 1.50m 3.70 m 2.60 m 69.3° 71.1° 56.6° F2 F3

A:

Q: The drive belt on a vintage sander transmits ½ hp to a pulley that has a diameter of d = 4 in.…

A: Given   data as per questiondiameter  =4 in=0.1016 mPower=12hp=372.85 wattN=1450…

Q: 1. Determine the stretch in each of the two springs required to hold the 20-kg crate in the…

A:

Q: springs having the stiffness shown. Determine the stretch of spring AC, S(AC): Select one: a. S(AC)…

A: