6. Find the angular momentum of a thin 6.9-kg rod of length7.5 m if it rotates about its midpoint at a speed of 750rpm.7. A sharp force of 0.75 KN is applied to the edge of a wheel freeto rotate. The force acts for 0.069 s. What is the final angularvelocity?

As we know, The angular momentum of a rod of mass m, (L) = m v r where angular speed (ω) = v / r…

Answered: 6. Find the angular momentum of a thin…

6. Find the angular momentum of a thin 6.9-kg rod of length 7.5 m if it rotates about its midpoint at a speed of 750rpm.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 94AP: A top has moment of inertia 3.2104kgm2 and radius 4.0 cm from the center of mass to the pivot point....

See similar textbooks

Related questions

Q: Give some examples of transitional, rotational, and combinational motion?

A: Introduction: When the whole body moves on the same point in a given time, then the motion is said…

Q: A 90-horsepower outboard motor at full throttle will rotate its 15in long propellers at 5000rpm.…

Q: A drum, when rotating at 839 rev/min, has a kinetic energy of 0.56MJ. Find the moment of inertia

A: Solution: Given, Speedw = 839 rev/minKinetic energyK.E = 0.56 MJ = 0.56 ×106J

Q: 21. Find the angular velocity of the given function when the time is equal to 8s. 0 = 5t² + 2t³ Ꮎ

A: We know thatω=dθdtWhereω=angular velocityθ=anglet=time

Q: 50 rom 1000 mm 300 mm 3. Determine the centroidal moment of inertia about the X axis.

Q: A drum rotates around its central axis at an angular velocity of 10.9 rad/s. If the drum then slows…

Q: A 2.25 kg thin spherical shell rolls without slipping across a level surface, translating at 4.00…

Q: drum rotates around its central axis at an angular velocity of 18.3 rad/s. If the drum then slows at…

A: Given Initial angular velocity =18.3 rad/s Final angular velocity =0 Angular acceleration =…

Q: 7. Create the angular velocity(q)for each of the following frequencies а) 100 Hz b) 5 kHz с) 2 МНHZ

A: We know that the expression for the angular frequency is given as ω=2πfHere,ω is the angular…

Q: A drum rotates around its central axis at an angular velocity of 13.8 rad/s. If the drum then slows…

Q: A drum rotates around its central axis at an angular velocity of 16.3 rad/s.If the drum then slows…

Q: 9. What in the angular frequeney if an object vibrates with a frequency of 5 Hz? a. 5 rad/s b. 31.42…

Q: A pendulum which drops sand as it swings back and forth is shown. This pendulum has been swinging…

A: (1) A heavy and massive pendulum is oscillating. This pendulum is found to have changing the…

Q: A drum rotates around its central axis at an angular velocity of 11.3 rad/s. If the drum then slows…

A: Write the given data. ω0=11.3 rad/sα=-7.97 rad/s2

Q: A 5 kg disk with a radius of 6 cm is rolling on a level surface with a velocity of 7 m/s. What is…

A: mass of disk = 5 kg radius = 6 cm v = 7 m/s

Q: A small ball of mass 1.1 kg is attached to one end of a 0.700-m-long massless rod, and the other end…

Q: Write down Hooke’s Law (equation) and give the units of the spring constant, k AND write down…

A: We will write down the laws and equations.

Q: 2. A winding drum of an elevator is 3.5 meters in diameter. The cab is raised at 91 m/min and has a…

A: The given data are listed below with appropriate variables. Here, r denotes the drum’s radius, v…

Q: 2-(0.4kg) A particle was Hanged, calculate the angular velocity, frequency and periodic time. (K =…

Q: E :6.00 m at + 0.900 rad F : 5.00 m at - 75.0° G : 4.00 m at + 1.20 rad H : 6.00 m at - 210°

A: Given, VectorsE→ = 6.0 m at +0.900 radF→ = 5.0 m at -75.0°G→ = 4.0 m at +1.20 radH→ = 6.0 m at -210°

Q: 3- Maxwell's wheel, mass 0.436Kg, radius 0.25cm, had a displacement of 0.8m during 7.53sec. Find how…

A: The given data are: m=0.436 kgr=0.25 cm=0.0025 md=0.8 mt=7.53 s Here, m denotes the mass, r denotes…

Q: The angular frequency of the hour hand on a wall clock in rad/sec is

Q: A drum rotates around its central axis at an angular velocity of 18.8 rad/s. If the drum then slows…

Q: The angular frequency of the hours hand on a wall clock in rad/sec is

Q: A radio turntable has a frequency 33 rpm. A record of radius is 15.25 cm is placed on the turntable…

Q: A drum rotates around its central axis at an angular velocity of 12.8 rad/s. If the drum then slows…

A: Given(s): Initial angular velocity, ω0=12.8 rad/s Finally, it comes to rest, therefore, ωf=0.…

Q: A drum, when rotating at 739 rev/min has a kinetic energy if 0.56MJ. Find the moment of inertia

Q: 10) Find moment of inertia of a disk rotating about its center of mass 550 Kg and diameter of 120…

Q: A drum rotates around its central axis at an angular velocity of 12.9 rad/s. If the drum then slows…

Q: A small ball of mass 0.49 kg is attached to one end of a 1.60-m-long massless rod, and the other end…

A: Given Information:- Mass of the ball is m=0.49 kg Length of the rod is l=1.60 cm Angle θ=20°…

Q: 1.1kg bike wheel, is spinning 190rpm clockwise when a student applies a rictional force as shown.…

Q: A gyroscope has a 0.5-kg disk that spins at 40 rev/s. The center of mass of the disk is 10 cm from a…

A: The expression to calculate the precession angular velocity is, ωP=rMgIω M: mass of the gyroscoper:…

Q: 11.Two points are on a uniformly rotating disk: the first is at a distance 5 cm from the axis of…

A: Total acceleration of a point on a rotating disc is the resultant of radial and tangential…

Q: A string trimmer is a tool for cutting grass and weeds; it utilizes a length of nylon "string" that…

Q: 2-(0.4kg) A particle was Hanged, calculate the angular velocity, frequency and periodic time. (K 20…

A: Mass of particle (m) = 0.4 kg Spring constant (k) = 20 Nm

Q: 4. A simple pendulum has a length of 1.5 m and a mass of 5 kg attached to its end. The pendulum's…

Q: A drum rotates around its central axis at an angular velocity of 12.1 rad/s. If the drum then slows…

Q: Calculate the angular speed, in rads of a flywheel turning at 750.0rpm

A: Flywheel is rotating at 750 RPM

Q: A small ball of mass 0.93 kg is attached to one end of a 1.30-m-long massless rod, and the other end…

Q: How is oscillations or vibrations related to circular/rotational motion?

A: When an object is displaced from its position and it starts to move back and forth about it's fixed…

Q: 3 You apply equal torqueJ to tuoo diferent cylinden one o which tw ice larger than the other, each…

A: Let equal torque τ be applied to two cylinders having moment of Inertia I1 and I2 such that I1=2I2.…

Q: 14. The time required for a rotating, revolving, or vibrating object to complete on cycle is the…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: A drum, when rotating at 939 rev/min, has a kinetic energy of 0.56MJ. Find the moment of inertia

Q: A pendulum which drops sand as it swings back and forth is shown. This pendulum has been swinging…

A: The arrangement of the pendulum given is called Foucault's Pendulum. It was designed by French…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

6. Find the angular momentum of a thin 6.9-kg rod of length
7.5 m if it rotates about its midpoint at a speed of 750rpm.
7. A sharp force of 0.75 KN is applied to the edge of a wheel free
to rotate. The force acts for 0.069 s. What is the final angular
velocity?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A top has moment of inertia 3.2104kgm2 and radius 4.0 cm from the center of mass to the pivot point. If it spins at 20.0 rev/s and is precessing, how many revolutions does it precess in 10.0 s?
(a) What is the angular speed of the second hand of a clock? (b) What is the direction of as you view a clock hanging on a vertical wall? (c) What is the magnitude of the angular acceleration vector of the second hand?
During a 6.0-s time interval, a fly-wheel with a constant angular acceleration turns through 500 radians that acquire an angular velocity of 100 rad/s. (a) What is the angular velocity at the beginning of the 6.0 s? (b) What is the angular acceleration of the fly-wheel?
The axis of Earth makes a 23.5 angle with a direction perpendicular to the plane of Earth’s orbit. As shown below, this axis precesses, making one complete rotation in 25,780 y. (a) Calculate the change in angular momentum in half this time. (b) What is the average torque producing this change in angular momentum? (c) If this torque were created by a pair of forces acting at the most effective point on the equator, what would the magnitude of each force be?
Integrated Concepts An ultracentrifuge accelerates from rest to 100,000 rpm in 2.00 min. (a) What is its angular acceleration in rad/s2? (b) What is the tangential acceleration of a point 9.50 cm from the axis of rotation? (c) What is the radial acceleration in m/s2 and multiples of g of this point at full rpm?
Dr. Rhee wrapped a string tightly around a fixed pulley that has a moment of inertia of 0.0352 kg m2 and a radius of 12.5 cm. Then he pulls the string away from the pulley with a constant force of 5.00N. What is the speed of the string after it has unwound 2.31 m? O a. 2.09 m/s O b.4.95 m/s O c. 3.18 m/s O d. 2.36 m/s O e. 1.97 m/s
8. A 3 kg uniform disk has a radius of 2 m. An external torque of 10 N-m is applied to the outside of the hoop for 10 sec. а. What is the angular acceleration? b. What is its angular speed after 10 sec? с. How much KE does the disk have after 10 sec. d. How much work did the external torque do on the disk? What is the linear velocity of a point on the outside of the disk after 10 sec? е.
22. The drill bit of a variable -speed electric drill has a constant angular acceleration of 2.50rad/s^2. The initial angular speed of the bit is 5 rad/s. After 4 seconds, what is the bit’sangular speed?A. 13 rad/sB. 15 rad/sC. 9 rad/sD. 20 rad/s
A disk with a diameter of 30 cm speeds up from 20 rad/s to 40 rad/s in 20s. (a) How many revolutions will the disk go through during that time period? (b.) What is the average linear acceleration of the disk? a.85 rev; 0.30 m/s^2 b. 96 rev; 0.30 m/s^2 c. 96 rev; 0.15 m/s^2 d. 85 rev; 0.15 m/s^2
8. Two masses of mass 10.0 and 6.0 kg are hung from massless strings at the end of a light rod. The rod is virtually weightless. A pivot (fulcrum) is placed off center and the system is free to rotate. If the 6.0 kg mass is 4.0 m away from the pivot, how far away is the 10.0 kg mass if the system is not rotating? a. 0.42 m c. 4.8 m d. 2.4 m b. 4.2 m Write your Solution here:
Kg. m^2 (kilogram. meter square) is the unit of O a. moment of inertia O b. rotational kinetic energy O c. angular acceleration O d. angular momentum
6. When an electric motor is turned on at t =0, its angular acceleration is ? = 10e-0.5twhere t is the time in seconds. What is theterminal angular velocity of the motor inrpm? 7. Referring to problem 6, how manyrevolutions are required for the motor toreach half of its terminal angular velocity.