i need the answer quickly value of 0 for which the tension in cordOB is as small as possible, (b) thecorresponding value of the tension, (c)the reactions at A and D.[6]. A slender rod AB, of mass m, is attachedto blocks A and B which move freely inwwthe guides shown. The constant of thespring is k, and the spring is unstretchedwhen 0 = 0. (a) Neglecting the mass ofWBthe blocks, derive an equation in m, g, k,I, and 0 which must be satisfied whenthe rod is in equilibm.Determinethe value of0 when m = 2 kg, I = 750mm, and k = 30 N/m.

[6]. A slender rod AB, of mass m, is attached to blocks A and B which move freely in the guides shown. The constant of the spring is k, and the spring is unstretched when 0 = 0.(a) Neglecting the mass of the blocks, derive an equation in m, g, k, I, and 0 which must be satisfied when the rod is in equilibrium. (b) Determine the value of 0 when m 2 kg, I = 750 mm, and k = 30 N/m.

[6]. A slender rod AB, of mass m, is attached to blocks A and B which move freely in the guides shown. The constant of the spring is k, and the spring is unstretched when 0 = 0.(a) Neglecting the mass of the blocks, derive an equation in m, g, k, I, and 0 which must be satisfied when the rod is in equilibrium. (b) Determine the value of 0 when m 2 kg, I = 750 mm, and k = 30 N/m.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Solution for A weight W = 500 KN rests on the weightless and friction less bar AB. The cable connecting W and point B passes over a frictionless pulleys. Find the Reaction (Ra) at point A.
A 12-ft wooden beam weighing 80 lb is supported by a pin and bracket at A and by cable BC. Find the reaction at A and the tension in the cable.
The mechanism shown consists of a crank (bar AB), a connecting rod (bar BC) and the piston C that slides on the smooth surface (without friction) The combustion of gasoline produces a force P on the piston and this is maintained in equilibrium with moment M applied at A. The length of the crank is 78 mm, of the connecting rod is 279 mm, the moment is 84 nm, and the angle theta is 0.41 radians. Determine the value of P in Newtons P B M
A man raises a 10-kg joist with a length of 4 m by pulling on a rope.Find the tension T in the rope and the reaction at A.
The bent rod in Fig. a is supported at A by a journal bearing, at D by a ball-and-socket joint, and at B by means of cable BC. Using only one equilibrium equation, obtain a direct solution for the tension in cable BC. The bearing at A is capable of exerting force components only in the z and y directions since it is properly aligned on the shaft. In other words, no couple moments are required at this support. 1 m B 0.5 m .Free-Body Diagram. As shown in Fig. b, there are six unknowns 0.5 m Equations of Equilibrium. The cable tension T, may be obtained directly by summing moments about an axis that passes through points D and A. Why? 100 kg
Solve the reaction forces.
find the reactions for each.
A 300mm wooden beam weighing 54kg is supported by a pin and a bracket at A and by a cable BC. Find the reaction at A and the tension in the cable
Find horizontal reaction H
ABC (fig. 3) is acted upon by a 455 N force. The pole is held by a ball and socket joint at A and by two cables BD and BE. For a= 3m, determine the tension in each cable, and the reactions (A., Ay, and A.) at A: %3D
Two reservours with different liquilds A (s.g 0.8) and B (s.g 1.5) are connected by a 1m square opening hole. The homogeneous cylinder (s.g 2.0), with 1 m long, is used to block the hole. Determine the magnitude and direction of the reactions at the upper and lower edges (s and m) of the opening. S=0.8 6m A S=1.5 5m 45° Im in
EQULIBRIUM OF RIGID BODIES - 3D The 6-m pole ABC is acted upon by a force P as shown. The pole is held by a ball-and-socket joint at A and by two cables BD and BE. If the tension in cable BE is 251 N and if a = 3m, determine the magnitude of the reaction (N) at A along the z-axis. Round off only on the final answer expressed in 3 decimal places.