500MVA, 21KV, star connected, 3ph 50Hz synchronous generator is operating at the rated voltage, a 3ph fault occurs at its terminal. Its reactance in p.u. are 1.5 of synchronous, 0.5 of transient, 0.2 of sub transient. The transient time is 500ms and the sub transient time is 35ms. 1. What will the AC component be after 1.5 cycles?

500MVA, 21KV, star connected, 3ph 50Hz synchronous generator is operating at the rated voltage, a 3ph fault occurs at its terminal. Its reactance in p.u. are 1.5 of synchronous, 0.5 of transient, 0.2 of sub transient. The transient time is 500ms and the sub transient time is 35ms. 1. What will the AC component be after 1.5 cycles?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter7: Symmetrical Faults

Section: Chapter Questions

Problem 7.6MCQ

See similar textbooks

Similar questions

The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of an unloaded synchronous machine decreases from a high initial value to a lower steady-state value, going periods through the stages of __________ and ________ periods.
Protection Schemes for Series Capacitor (compensation )
Impulse flashover test is conducted to know the characteristics of insulators and lightning arrestors in negative half cycle only True False
The brushes width in Wave winding is equal to a. 1.5 commutator segments. b. 1 of commutator segments. c. 1.25 commutator segments.
The ripple factor for pure dc is Answer:
An alternating current varying sinusoidally with a frequency of 50 Hz has anrms value of 20 A.a) Determine the instantaneous value at 0.0025 seconds.b) Determine the instantaneous value, 0.0125 seconds after passingthrough a positive maximum value.c) At what time, measured from a positive maximum value, will theinstantaneous current be 14.14 A?
why is there a phase shift in rc cct?how do we make it exactily 90 degree?
What is the difference between OLTC and transformers
In 2-pole machines: the wave winding have greater generated voltage than *.the lap winding armatures True False *.For high rotating speed machines the number of poles must be Little True False The reactance voltage is added in the coil undergoing commutation to * reduce the spark True False
The reactance’s of the alternator during the periods of the subtransient, transient and steady state periods are following, Leakage reactance(XL)=0.13 ohm, Damper winding reactance(XD)= 0.27 ohm Field winding reactance(Xf)=0.54 ohm and Armature reactance (Xm)= 0.73 ohm. The value of the transient reactance during the transient conditions is Transient Reactance
The reactance's of the alternator during the periods of steady state are given bellow, Leakage reactance(X)=0.18 ohm, and armature reactance (Xad) = 0.67 ohm. The value of the syncronous reactance during the steay state conditions is Syncronous Reactance in ohm
In small transformers, the total copper loss may vary from the rated output. % of O 0.2 to 0.6 O 0.5 to 1 O 0.8 to 1.5 O 0.4 to 1