5. Using the circuit symbols (lesson 4), label the circuit diagram. Be sure to classify the circuit as open, closed, fused, or short (may be more than one). 6. An electric motor has an operating resistance of 252 when a 4.8A current is flowing through it. What is the potential difference of the outlet the motor is plugged into?

5. Using the circuit symbols (lesson 4), label the circuit diagram. Be sure to classify the circuit as open, closed, fused, or short (may be more than one). 6. An electric motor has an operating resistance of 252 when a 4.8A current is flowing through it. What is the potential difference of the outlet the motor is plugged into?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Solve the following: 1. A certain light bulb has a resistance of 150 when lighted. How much current will flow through it when connected across a 220 V, its normal operating voltage? Draw the circuit schematic diagram>Fin 2. Find the potential difference (Emf) in a certain electric circuit with current flowing at 18 ampere and a floor Polisher connected with resistance of 12 ? 3. A 12 volts battery operates a 15 ohms digital scale for 5.2 minutes. a) Find the current flowing b) the charges Transferred with the given time. 4. What is the resistance of a conductor at 50° C if its resistance at 0°C is 1 ohm and the temperature coefficient of resistance of 9.8 x 10-³/°C 5. A silver wire has a resistance of 2.3 at 0°C and a temperature coefficient of resistance of 3.75 x 10-³/°C. What is final temperature when the final resistance is 3.8 ohms. ? 6. Complete the table: Electric Circuit and Ohm's Law V, Volts 8 volts 20 volts 10 Volts 36 volts I, Ampere 2.8 mA 40A 130mA R, ohms 156 02 25 ΚΩ…
Explain the following 1. What happens to the equivalent resistance as the resistors are added in?? (a) series(b) parallel2. as a consequence of adding resistors in(a) Series(b) parallelwhat happens to the total current flowing in the circuit?3. how do you compare the currents and voltages with resistors connected in series and in parallel?
If three resistors connected in series to a battery. Suppose R1 carries a current of 22.5A, R2 has a resistance of 150, and R3 dissipates 60W of power. What is the voltage across R3 and Resistance of R3 ? 1. Voltage across R3 %3D and 2. Resistance of R3 =
Solve the following: in light bulb has a resistance of 150 when lighted. How much current will flow through it when connected acro 220 V, its normal operating voltage? Draw the circuit schematic diseam>Fin 2. Find the potential difference (Em) Polisher connected wi 3. A 12 battery operates a 15 ohms digital scale for 5.2 minutes. a) Find the current flowing b) the charges erred with the given time. 4. What is the resistance of a conductor at 50° C if its resistance at 0°C is 1 ohm and the temperature coefficient of resistance of 9.8 x 10-³/°C 6. Complete the table: 5. A silver wire has a resistance of 2.3 at 0°C and a temperature coefficient of resistance of 3.75 x 10-³/°C. What is final temperature when the final resistance is 3.8 ohms. ? V, Volts Electric Circuit and Ohm's Law 8 volts 20 volts ca elecun it with current flowing at 18 ampere and a floor rice of 12 Q? 10 Volts 36 volts I, Ampere 2.8 mA 40A 130mA R, ohms 156 02 25 ΚΩ 450 ΚΩ
DIFFERENTIAL EQUATION: Electric Circuits. Solve the following problems. Show your complete solution. When a resistance R (ohms) and a capacitance C (farads) are connected in series with an emf E (volts), the current I (amperes) is given by the equation: dI 1 dE +-I = dt C R dt If R = 1000 ohms, C = 5x10-4farad.and I = 10 amperes for t = 0, find the current for t = 1 second and E = 100 volts.
Answer the following questions about the circuit below. a. Find the total resistance of the circuit. b. Find the total current of the circuit. c. What is the current through R1? d. What is the current through R2? What is the current through R3? e. What power is dissipated by R1? f. What power is dissipated by R2?
2.1:Draw a circuit diagram of the circuit 2.2:Briefly explain how to connect an ammeter to measure the current in the circuit. 2.3:Briefly explan how to connect a voltmeter to measure the potential difference across a resistor in the circuit. 2.4: explain whether it matters where the ammeter is connected in the circuit. 2.5:explain whether it matters where the voltemeter is connected in the circuit.
1. Fill in the table for this circuit. Show your work (you can a picture and insert it in this document) and then check your answer with PhET, and insert a screenshot of your circuit. To get the “big” resistor (kilo-ohms) you have to hit the down arrow on the left selection panel. It is the resistor with no color bands on it.
Solve the following: 1. Find a) Draw the schematic diagram of the circuit and label, b) the total resistance of the four loads having the following resistances: 6, 8, 10, and 9 ohms. If they are connected in: a) series b) parallel 2. The resistances of three resistors are 12, 15, and 9 ohms. These resistors are connected in parallel across a 35 volts battery. Find : a) Draw the schematic diagram of the circuit and label b) the total resistance of the circuit c) the total current of the circuit d) Current in each of the resistor. 3. The resistances of three resistors are 12, 15, and 9 ohms. These resistors are connected in series across a 35 volts battery. Find : a) Draw the schematic diagram of the circuit and label b) the total resistance of the circuit c) the total current of the circuit d) Voltage across each resistor 4. The resistances of four resistors are 2, 3, 5 and 8 ohms connected across 12 volts battery. The first two resistances and the last two are connected in parallel…
If three resistors connected in series to a battery. Suppose R, carries a current of 8A, R, has a resistance of 7.50, and R; dissipates 80W of power. What is the voltage across Ry and Resistance of Ry ? 1. Voitage (in V) across R3 = and 2. Resistance (in ) of R: =
1. Calculate the resistance of a resistor that has a voltage (potential difference) of 8 V across itwhen a current of 2 A flows through it. Draw the circuit diagram before doing the calculation. 2. Two 10 kΩ resistors are connected in series. Calculate the equivalent resistance. Draw the circuitdiagram before doing the calculation.
1. Please draw a circuit diagram for a 15 V battery that is in series with a 5-ohm resistor, has an open switch, and a .75 uF capacotir. Then find the circuit's time constant in us. 2. Find the initial curent when the swith is closed at t=0s and use the initial current plue the time constant to create a mathematical expression for the current as a function of time, I(t). Please include a drawing of I(t) from t=0 to t=5 RC 3. Use the expression you created in 2 to find the current at t=.010ms 4. Find the charge Q on the capacitor plates when they are fully charged. Write another mathematical expression for the capactitor charge as a function of time using the charge Q plus the time constant. Include a drawing of Q(t) from t=0 to t=5RC. 5. Use the expression you created in 4 to find voltage across the capacitor plates at t=.010ms. (just the first three)