49.410% potassium, sulfur, and 30.32% oxygen are found to be in a sample found in an unlabeled container. What is the empirical formula of this compound? . Write the K then the S then the O. • Do NOT use a ZERO to represent the O or the system will count your answer as wrong.) . You will not be able to type subscripts. Just type the numbers where they go. For example, S₂03 would be typed in as 5203.

49.410% potassium, sulfur, and 30.32% oxygen are found to be in a sample found in an unlabeled container. What is the empirical formula of this compound? . Write the K then the S then the O. • Do NOT use a ZERO to represent the O or the system will count your answer as wrong.) . You will not be able to type subscripts. Just type the numbers where they go. For example, S₂03 would be typed in as 5203.

World of Chemistry, 3rd edition

3rd Edition

ISBN:9781133109655

Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Chapter6: Chemical Composition

Section: Chapter Questions

Problem 4STP

See similar textbooks

Similar questions

Two general chemistry students working together in the lab weigh out 0.832 g of CaCl2 2 H2O into a crucible. After heating the sample for a short time and allowing the crucible to cool, the students determine that the sample has a mass of 0.739 g. They then do a quick calculation. On the basis of this calculation, what should they do next? (a) Congratulate themselves on a job well done. (b) Assume the bottle of CaCl2 2 H2O was mislabeled; it actually contained something different. (c) Heat the crucible again, and then reweigh it.
In an experiment, you need 0.125 mol of sodium metal. Sodium can be cut easily with a knife (Figure 2.5), so if you cut out a block of sodium, what should the volume of the block be in cubic centimeters? If you cut a perfect cube, what is the length of the edge of the cube? (The density of sodium is 0.97 g/cm3.)
The present average concentration (mass percent) of magnesium ions in seawater is 0.13%. A chemistry textbook estimates that if 1.00 × 108 tons Mg were taken out of the sea each year, it would take one million years for the Mg concentration to drop to 0.12%. Do sufficient calculations to either verify or refute this statement. Assume that Earth is a sphere with a diameter of 8000 mi, 67% of which is covered by oceans to a depth of 1 mi, and that no Mg is washed back into the oceans at any time.
With the advent of techniques such as scanning tunneling microscopy, it is now possible to write with individual atoms by manipulating and arranging atoms on an atomic surface. a. If an image is prepared by manipulating iron atoms and their total mass is 1.05 1020 g, what number of iron atoms were used? b. If the image is prepared on a platinum surface that is exactly 20 platinum atoms high and 14 platinum atoms wide, what is the mass (grams) of the atomic surface? c. If the atomic surface were changed to ruthenium atoms and the same surface mass as determined in part b is used, what number of ruthenium atoms is needed to construct the surface?
A compound associated with the odor of garlic on a persons breath has the chemical formula CyH8S and a formula mass of 88.19 amu. What number does y stand for in the chemical formula of the compound?
In Groups 4A-6A, there are several elements whose symbols begin with S. Name these elements, and for each one give its symbol, atomic number, group number, and period. Describe each as a metal, metalloid, or nonmetal.
Atomic masses are relative masses. What does this mean?
Saccharin, a molecular model of which is shown below, is more than 300 times sweeter than sugar. It was first made in 1807, when it was common practice for chemists to record the taste of any new substances they synthesized. (a) Write the molecular formula for the compound, and draw its structural formula. (S atoms are yellow.) (b) If you ingest 125 mg of saccharin, what amount (moles) of saccharin have you ingested? (c) What mass of sulfur is contained in 125 mg of saccharin?
3.107 As computer processor speeds increase, it is necessary for engineers to increase the number of circuit elements packed into a given area. Individual circuit elements are often connected using very small copper “wires” deposited directly onto the surface of the chip. In some processors, these copper interconnects are about 22 nm wide. How many copper atoms would be in a 1-mm length of such an interconnect, assuming a square cross section? (The density of copper is 8.96 g/cm3.)