3(a) A stationary object is acted upon by a number of forces.State the conditions which must be true if the object(i) does not accelerate,(in does not ratate.(b) Fig. 3.1 shows a boat that has been lifted out of a river. The boat is suspended by two ropes.It is stationary.1P1.20 mp.40 m24 kFig. 3.1 (not to scale)The weight of the boat, acting at the cente of mass, is 24 &N, The tensions in the ropes areTand T-Determine(i) the moment of the weight of the boat about the point P.moment(ii) the tension T,.(ii) the tension T

3(a) In this part, it is asking the conditions when the object does not accelerate and does not…

3 (a) A stationary object is acted upon by a number of forces. State the conditions which must be true if the object () does nat accelerate, (in does nat ratate. (b) Fig. 3.1 shows a boat that has been lifted out of a river. The boat is suspended by two ropes. It is stationary. 1.20 m þ40 m 24 Fig. 3.1 (not to scale) The weight of the boat, acting at the cectoe of mass, is 24 &N, The tensions in the ropes are Tand T. Determine (i) the moment of the weight of the boat about the point P, moment =. (ii) the tension T

3 (a) A stationary object is acted upon by a number of forces. State the conditions which must be true if the object () does nat accelerate, (in does nat ratate. (b) Fig. 3.1 shows a boat that has been lifted out of a river. The boat is suspended by two ropes. It is stationary. 1.20 m þ40 m 24 Fig. 3.1 (not to scale) The weight of the boat, acting at the cectoe of mass, is 24 &N, The tensions in the ropes are Tand T. Determine (i) the moment of the weight of the boat about the point P, moment =. (ii) the tension T

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. A girl weighing 604 N hangs suspended on the end of a rope 9.0 m. long. If a friend pushes her laterally to one side until the rope makes an angle of 38 ° with the vertical, what lateral force is required at this point? What is the tension of the rope ? if local g = 979 cm/s²? What is her mass in kg and in lbm . Ans. 471.897 N: 766.487 N: 61.696 Kg 136.04 lbm.
1. Pressures up to 3000 bar are measured with a dead-weight gauge. The piston diameter is 4 mm. What is the approximate mass in kg of the weights required? 2. A gas is confined in a 0.47 m diameter cylinder by a piston, on which rests a weight. The mass of the piston and weight together is 150 kg. The local acceleration of gravity is 9.813 m's-2, and atmospheric pressure is 101.57 kPa. (a) What is the force in newtons exerted on the gas by the atmosphere, the piston, and the weight, assuming no friction between the piston and cylinder? (b) What is the pressure of the gas in kPa? (c) If the gas in the cylinder is heated, it expands, pushing the piston and weight upward. If the piston and weight are raised 0.83 m, what is the work done by the gas in kJ? What is the change in potential energy of the piston and weight? 3. Steam at 1400 kPa and 350°C [state 1] enters a turbine through a pipe that is 8 cm in diameter, at a mass flow rate of 0.1 kg: s-1. The exhaust from the turbine is…
4. A curious astronaut took her bathroom scale (a spring scale) and a beam scale (compares masses) to the moon. On Earth, she determined that her mass was 124 Ibm. The gravitational acceleration on the moon is a = 5.3 ft/s?.When she reaches the moon: a.) What will she weigh on the spring scale? b.) What will the beam scale indicate for her mass?
4. If the modulus of elasticity (E) for water is given to be 2.2GPa, what pressure is required to reduce the volume by 0.6%? 5. A tank contains two substance oil (A) and water (B) subject to variable air pressure: the dimension is shown below and corresponds to 1atm If air is
1.14 In the hoist drive system shown in Fig.22 , the mass M is considered being moved upwards with negligible frictional torque. Show that the load torque and the equivalent moment of inertia are given by dwm Tm = Je dt W2 М.r Wm Je = Im + J1 + ( [J2 + M.r²] Wm Wm Om, Tm Ji Motor J2 2r Jm 02 gear Loss-free Fig.22.
1.18 The static equilibrium position of a massless rigid bar, hinged at point O and connected with springs kj and k2, is shown in Fig. 1.74. Assuming that the displacement (x) resulting from the application of a force F at point A is small, find the equivalent spring constant of the sys- tem, ke, that relates the applied force F to the displacement x as F = kex k = 2k A k2 = k FIGURE 1.74 Rigid bar connected by springs.
A 227 kg bear* is 15 ft up a tree when it falls onto a trampoline deforming it 3 ft (where it touches the ground). Neglecting friction and mass of the trampoline (and assuming the trampoline is a simple spring), what is the spring constant of the trampoline? 1 m = 3.3 ft * the bear was OK a. 24,470.60 N/m b. 2,441.93 N/m c. 741.53 N/m d. 7,415.33 N/m
%OA l. STATIC MONT... -> Find the resultant force of the following? B. 2 m F = 600 N 3.5 m 0.5 m F = 450 N 1.5 m 1m 1.5 m 0.5 m
An aircraft is getting loaded with checked luggage. The ramp that has a moving belt makes an angle of 60° with an aircraft body. The belt is stationary (Fig. 1a) a Fig. 1a Draw a free body diagram of a single luggage that is placed on the belt. Show weight as vertical and horizontal components. Suppose the belt now starts moving from rest, determine the acceleration of the bag and its speed after 2s. The mass of the bag is 22 kg, coefficient of kinetic friction u = 0.4 and the force produced by the belt on the bag Faet = 120 N. ii
Q2:An open belt 100 mm wide connects two pulleys mounted on parallel shafts with their centers 2.4 m apart. The diameter of the larger pulley is 450 mm and that of the smaller pulley 300 mm. The coefficient of friction between the belt and the pulley is 0.3 and the maximum stress in the belt is limited to 14 N/mm width. If the larger pulley rotates at 120 r.p.m., find the maximum power that can be transmitted . [Ans. 2.387 kW]
Bugs Bunny (m=32 kg) starts at rest atop a h;=33 m tall hill, and then slides down. After that, Bugs: I.) slides into a swing set at the bottom of the hill, which has a R = 11 m long chain. He swings up and over the bar, with the chain managing to stay taut. (Labelled points A, B & C are at the bottom, side and top of the loop respectively.) %| II.) continues on flat ground, where he then hits a friction patch which is L=41.25 m long, from which he exits (at labelled point D) at speed vp 17.98 m/s. III.) slides off a cliff that is hp=17 m tall, into a lake. C h, D Vo R FL- Part I: (around the swing set) a.) Sketch in the correct directions of all forces that act on Bugs at each of the points A-C. Note: At point A, Bugs has already lifted his feet off the ground.
A group of athletes were tested for isometric endurance by measuring the length of time they could resist a load pulling on their legs while seated. The approximate amount of time (called the holding time) that they could resist the load was given by the formula t = 31,293w^-1.5, where w is the weight of the load in pounds and the holding time t is measured in seconds. a. Determine the holding time for a load of 29 lb. b. When the weight of the load is tripled, by what factor is the holding time changed?