20°C 25°C During day time, water is colder than the sand. Which has higher specific heat capacity, water or sand? * O Incomplete information is given. O Sand, as increases its temperature increases easily. O Sand, as it needs less energy to increase its temperature O Water, as it needs more energy to increase its temperature.

20°C 25°C During day time, water is colder than the sand. Which has higher specific heat capacity, water or sand? * O Incomplete information is given. O Sand, as increases its temperature increases easily. O Sand, as it needs less energy to increase its temperature O Water, as it needs more energy to increase its temperature.

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter20: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 37AP: The latent heat of vaporization for water at room temperature is 2 430 J/g. Consider one particular...

See similar textbooks

Similar questions

A person inhales and exhales 2.00 L of 37.0C air, evaporating 4.00102g of water from the lungs and breathing passages with each breath. (a) How much heat transfer occurs due to evaporation in each breath? (b) What is the rate of heat transfer in watts if the person is breathing at a moderate rate of 18.0 breaths per minute? (c) If the inhaled air had a temperature of 20.0C, what is the rate of heat transfer for warming the air? (d) Discuss the total rate of heat transfer as it relates to typical metabolic rates. Will this breathing be a major form of heat transfer for this person?
(a) It is difficult to extinguish a fire on a crude oil tanker, because each liter of crude oil releases 2.80107J of energy when burned. To illustrate this difficulty, calculate the number of liters of water that must be expended to absorb the energy released by burning 1.00 L of crude oil, it the water has its temperature raised from 20.0C to 100C, it boils, and the resulting steam is raised to 300C. (b) Discuss additional complications caused by the fact that crude oil has a smaller density than water.
(a) The number of kilocalories in food is determined by calorimetry techniques in which the food is burned and the amount at heat transfer is measured. How many kilocalories per gram are there in a 5.00g peanut if the energy from burning it is transferred to 0.500 kg of water held in a 0.100kg aluminum cup, causing a 54.9C temperature increase? (b) Compare your answer to labeling information found on a package of peanuts and comment on whether the values are consistent.
The latent heat of vaporization for water at room temperature is 2 430 J/g. Consider one particular molecule at the surface of a glass of liquid water, moving upward with sufficiently high speed that it will be the next molecule to join the vapor. (a) Find its translational kinetic energy. (b) Find its speed. Now consider a thin gas made only of molecules like that one. (c) What is its temperature? (d) Why are you not burned by water evaporating from a vessel at room temperature?
(a) How much heat transfer is required to raise the temperature of a 0.750kg aluminum pot containing 2.50 kg of water from 30.0C to the boiling point and then boil away 0.750 kg of water? (b) How long does this take if the rate of heat transfer is 500 W 1watt=ljoule/second(lW=lJ/s) ?
On a hot day, the temperature of an 80,000L swimming pool increases by 150C. What is the net heat transfer during this healing? Ignore any complications, such as loss of water by evaporation.
(a) A woman climbing the Washington Monument metabolizes 6.00102kJ of food energy. If her efficiency is 18.0%, how much heat transfer occurs to the environment to keep her temperature constant? (b) Discuss the amount of heat transfer found in (a). Is it consistent with the fact that you quickly warm up when exercising?
In my humid climates where there are numerous bodies of water, such as in Florida, it is unusual for temperatures to rise above about 35C(95F). In deserts, however, temperatures can rise far above this. Explain how the evaporation of water helps limit high temperatures in humid climates.
One method at getting a tight fit, say of a metal peg in a hole in a metal block, is to manufacture the peg slightly larger than the hole. The peg is then inserted when at a different temperature than the block. Should the block he hotter or colder than the peg during insertion? Explain your answer.
(a) Calculate the rate of heat conduction through house walls that are 13.0 cm thick and that have an average thermal conductivity twice that of glass wool. Assume there are no windows or doors. The surface area of the walls is 120m2 and their inside surface is at 18.0C, while their outside surface is at 5.00C. (b) How many 1-kW room heaters would be needed to balance the heat transfer due to conduction?
In some countries, liquid nitrogen is used on dairy trucks instead of mechanical refrigerators. A 3.00-hour delivery trip requires 200 L of liquid nitrogen, which has a density at 808kg/m3. (a) Calculate the heat transfer necessary to evaporate this amount of liquid nitrogen and raise its temperature to 300C. (Use cp and assume it is constant over the temperature range.) This value is the amount of cooling the liquid nitrogen supplies. (b) What is this heat transfer rate in kilowatthours? (c) Compare the amount of cooling obtained from melting an identical mass at 0C ice with that from evaporating the liquid nitrogen.
Unreasonable Results (a) Calculate the rate of heat transfer by conduction through a window with an area of 1.00 m2 that is 0.750 cm thick, if its inner surface is at 22.00C and its outer surface is at 35.00C (b) What is unreasonable about this result? (c) Which premise or assumption is responsible?