163. A capacitance is charged to 100 V and has 100 micro coulombs of charge. The value of capacitance will be
Q: What is the energy Bauit?
A:
Q: What determines if a standard buck converter is synchronous rather than asynchronous? A. The low…
A: Buck converter is converters DC to DC , it is used for converting high voltage level to low…
Q: Q2// A double-cage of a 3-phase, 60-Hz, 4-pole induction motor, the impedance of outer and inner…
A:
Q: A machine is capable of a power output of 10 W ± 3 dB. What is the possible power fluctuation?
A: Given: Power output, P=10W±3dB
Q: In the circuit shown in Fig. 6.24, the total charge is 750 µC. Determine the values of V₁, V and C₂.
A:
Q: There are 72 slots in a 3-phase, 8-pole, 50 Hz, star connected alternator. There are 2 conductors in…
A:
Q: Produce a graph showing current I against the diode voltage VD. - Current (ID) vs Voltage (VD)
A: The above tabular information shows the characteristics of the diode in forward bias condition…
Q: 7. A 4-pole machine running at 1500 r.p.m. has an armature with 90 slots and 6 conductors per slot.…
A: This is a problem of dc machines. Here the answer given is incorrect. I am providing the complete…
Q: 60 V 5 A Μ 8 Ω 4 Ω ww ' 10 Ω 2 Ω 2 εἰς
A: Given circuit:- We have to determine the value of Vx.
Q: Find the equivalent decimal number for the BCD "1111010101111111"
A: The same value in decimal form is referred to as equivalent decimals. The number 2 serves as the…
Q: Please answer fast A transformer has a rated output of 400 kVA at a power factor of 0.6. Determine…
A:
Q: non-sinusoidal quasi-square wave voltage v(t) is applied to a nonlinear load, resulting in a…
A:
Q: A three phase transmission line has an impedance per wire of 5+j15 ohms. The receiving end has the…
A: In the given questions, we need to find the sending end voltage.
Q: a a. be 10Ω www 30 Ω ; 5Ω Μ 18 Ω ww 60 Ω 10 Ω www 35 Ω ww 75 Ω 50 Ω 20 Ω 40 Ω
A: Basics of resistance. Resistancae is define a opposition in flow of current in the electrical…
Q: In a short-circuit test on a 3-pole, 220 kV circuit breaker. Power factor of the fault = 0.8…
A:
Q: A transmission line has the following primary constants: resistance R = 15 /loop km, inductance L =…
A: According to the question, it is given that Resistance (R) = 15 Ω Inductance (L) = 3.4 mH…
Q: Use a Karnaugh map to simplify the following SOP expression: WXYZ+WXYZ + WXYZ + WYZ + WXYZ
A:
Q: How; find Exsol/Eis ei Ⓒ R₁ D 20000000 L с AMA R₂ 12 + Rs lo 1
A:
Q: The voltage across the 16-ohm resistor in the circuit is 80 V, positive at the upper terminal. a.…
A:
Q: A d.c. serier generator, having an external characteristic which is a straight line through zero to…
A: We have a DC series generator having an external characteristics which is straight line through 0 to…
Q: 1. Solve for the Laplace Transform of f(t) = 58(t) + 6e-4t - 7cos(5t).
A: Given: function f(t)=5δ(t)+6e-4t-7cos5t
Q: Map the expression A + CD + ACD + ABCD on a Karnaugh map. Use a Karnaugh map to simplify the…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Please explain why does the frqcy of the recovered signal is same with the information signal?…
A: Given: Carrier signal (2Vpk,20 kHz) Information signal (1Vpk,1kHz) Recovered signal (1kHz) To find:…
Q: The semiconductor CdSe has a bulk melting temperature of 1678 K. However if this material is formed…
A: Given data: A bulk melting temperature of =1678 K. Melting temperature significantly reduce to=1=700…
Q: What is the value of the current į through the 4 resistor in amps? 9V +1 3 Ω i 4 Ω 6Ω
A:
Q: (a) L-1 Determine 7s {3²2²+4) 4s -¹ { 12 +₁16) - (b) L-1
A:
Q: QUESTION 1: The reading operation in a floating gate transistor works as follows. First, we apply a…
A: A floating gate MOS transistor works in three region: Saturation Triode Cut-off In digital circuit…
Q: A long shunt d.c. compound generator delivers 110 kW at 220 V. If r = 0.01 ohm, r = 0.002 ohm, and…
A: We have been given an long shunt dc compound generator as shown in figure. Given data, Voltage (V)…
Q: Question- A permanent magnet moving coil type ammeter and moving iron type ammeter are connected in…
A: Given- moving coil ammeter & moving iron type ammeter in series. Half wave rectifier voltage…
Q: Map the following standard SOP expression on a Karnaugh map: ABCD+ABCD + ABCD + ABCD Map the…
A:
Q: 2. A three-phase motor draws 40 kVA at 0.65 power factor lagging from a 230 V source. A capacitor…
A: Given: SM=40 kVA, VM=230 V, P.FM=cosϕM=0.65.PM=SMcosϕM=40 kVA×0.65=26…
Q: Simplify the Boolean expression [AB(C+BD) + ABJCD.
A: Since you have asked multiple questions in a single request, we will be answering only the 1st…
Q: 6 Q/ how much The number of parallel resistances ? R1 M 2 R3 5 R2 M R5 3 R4
A:
Q: a- Why should the transition probability be calculated in terms of electric dipole moment rather…
A:
Q: PRACTICE EXERCISE 4.2 Three identical small spheres of mass m are suspended from a common point by…
A: Given: P is the common point, Fe = the force exerted by the other 2 spheres, mg = the force exerted…
Q: b- Using physical equations, is the number of photons in one joule of red light greater than, equal…
A: Given that w have to compare that no of photons in one joule of red light is greater,lesser and…
Q: At startup, an electric motor consumes substantially more
A: This has been answered below. All of the above mentioned options are discussed below and found the…
Q: Q1) For the circuit in Fig. 1, find V₁, Vz, and Vc for Rå – 100 kſ, 10 kſ, and 1 k2. Let -100. +3 V…
A: The given transistor is in an emitter bias configuration. When RB=100 kΩ. The required parameters…
Q: An ammeter has a f.s.d. of 100 mA and a resistance of 50 ohm. The ammeter is used to measure the…
A:
Q: Q6/To Design the following functions must using F1=[(0,2,4,7) F2=(3,5,7,11) *(F3=[(30, 60)…
A:
Q: 20 The alternating voltage e₂ in Fig. 24a is given by the expression e₂ = 20 cos (360 ft - 0) If =…
A:
Q: How do we increase or decrease the generated voltage output in the operation of a factory finished…
A: Basics An alternator or synchronous generator is a machine that is used for converting mechanical…
Q: A 47 resistor and a capacitor with a capacitive reactance of 120 are in series across an ac source.…
A: Given data: R=47ΩXc=120Ω
Q: + 6 Q/how much The number of meshes ? R1 2 R3 5 R2 m R5 3 R4 4
A:
Q: Determine the binary values for which the following SOP expression is equal to 1: XYZ + XYZ + XYZ +…
A:
Q: Given: the SISO LTI system: Determine: G(s) = s+10 s² +0.5s +1 2 a) the poles and zeros of the…
A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…
Q: Use a Karnaugh map to simplify the following standard SOP expression: XYZ + XYZ + XYZ + XYZ + XYZ +…
A:
Q: Determine L 4s - 5 s²-s-2
A: Given: L-14s-5s2-s-2
Q: A light bulb is rated at 100 W for a 220 V ac supply. The resistance of the bulb is then A B C D…
A: Given, Bulb rated power, P=100 W. Supply voltage, V=220 V.
Q: Produce a graph showing current I against the diode voltage VD. - Current (ID) vs Voltage (VD)
A: Given: Tables for voltage across diode and current through diode for forward bias and reverse bias.…
Step by step
Solved in 2 steps
- You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
- Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
- You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?80 V voltage is applied to the circuit with capacitors in the figure. a) Find the equivalent capacity? b) Find the total charge? c) Calculate the charge on capacitor C?
- What is the equivalent resistance ?? and what is the total inductance ??In the figure the potential difference V of the battery is 10V. Each capacitor C has a value C = 10 μF. What is the charge on the capacitor C1.A resistance of 12 ohms and capacitance of 0.01 farad is connected in series with a 200 volts battery. Find the charge after 0.5 second and the current after 0.4 second