12. A copper conductor has a diameter of 1.265 mm and length of 500 m, calculate the operating temperature when its resistance becomes 8 Q? 13. Calculelahmin valueof the Cilvor DIO Color coded an

Q: Example 1: Find the differential equations that describe the mesh currents iz and iz in the circuit....

A: We need to find out the differential equation for given circuit .

Q: The loosest type of coupling is   A. data coupling B. control coupling C. external coupling D. ...

A: Out of the given couplings data coupling will be the loosest coupling.  Generally loosest  coupling ...

Q: Question No. 4: For the below circuit, assume that: V:(t) = 20 sin(wt+30°) V2(t) = 10 cos(wt+30°) V3...

A: In this question,  Voltage equations are given.  Write the phasor representation of the given voltag...

Q: How did he get the value inside the circle? It is possible to explain step by step and how he got th...

A: The solution is given below

Q: 12) What is the minimum clock period for the circuit shown? D Q CIk 13) What are the setup and hold ...

A:

Q: Find out the field strength at 30 km away from a transmitting antenna of 625 kW power.

A:

Q: 4. A cylindrical steel pressure vessel 250 mm radius with a thickness of 20 mm, is subjected to an i...

A:

Q: 8. Determine voltages v1 through v3 in the circuit shown below using nodal analysis. [Use O instead ...

A:

Q: 4. Vo and In Si Ge IR +12 V - 5.6KQ

A: The solution is given below 

Q: A single-phase inductive load consists of a resistance R (in ohms) in series with an inductor L (in ...

A: It is given that: resistance=RInductance=LVoltage across load=Vrms∠0°frequency=ω      

Q: Prove that the expression: F (A,B,C)= (A+B) (A+BC) +A'B'+A'C' =1.

A: This question belongs to digital electronics. It is based on the concept of simplification of the fu...

Q: If you wanted to design a circuit to monitor the state of 16 discrete digital inputs using the least...

A:

Q: What does 2 Vpk mean? Is it the same as saying that the total circuit voltage is 2V

A: In this question  We need to explain the mean of 2Vpk  Check Is it the same as saying that the total...

Q: Two impedances Za = 4 – j7 W and Zb = 6+ j 9 W are connected in parallel connected to a 60 hz source...

A: In the question, Two impedances Za = 4 – j7 W and Zb = 6+ j 9 W are connected in parallel connected ...

Q: How many lines are there in an NTSC signal? a) 1024 b) 1856 c) 625 d) 525

A: 1. The majority of 60Hz-based countries employ the NTSC technology, which was created in the United ...

Q: For the circuit below calculate Zin in rectangular form if w = 100 rad/s L=0.04H R=10 V out C=0.25F

A:

Q: A 50 V range voltmeter is connected across the terminals "A" and "B" of the circuit shown in figure ...

A:

Q: ) The two different types of semiconductors obtained when adding two different impurities represente...

A: Impurities are of two types  1) pentavalent and trivalent impurities Pentavalent impurities are from...

Q: Determine each statement if it is TRUE or FALSE. A1. The sum of the homogeneous and particular solu...

A: A1. Answer: True Explanation: The response of any LTI system is the sum of the homogeneous solution ...

Q: *The current through a serier Re LC circuit ir 9'ven: d'i(t) + 6 di (t) dt si(t)=10UCH) dt • Assumin...

A:

Q: Given the points T (5, 20°, 120°) to P (2, 80°, 30°): find the unit vector in spherical coordinates ...

A:

Q: Pls show the step by step solution thank you. A certain current lags the voltage by 36 electrical d...

A:

Q: 120 V rms +. Z= 10 +j12 2 60 Hz What is the power factor if we change the nature of the impedance fr...

A: Option - A.   (Answer)

Q: Calculate the total memory in KiloBytes (KB) of a microcontroller with 18 bit address bus and 15 bit...

A: We have to calculate the memory in KB

Q: 3) The region where an amplifier is operating in a linear format is represented by: a) The positive ...

A: 3) The region where an amplifier is operating in a linear format is represented by:       4) For osc...

Q: Find the Minterm of f’ = (a + bc)’ and convert it to Maxterm.

A:

Q: Q2) Design a quarter-wave transformer to match a 100 load with a transmission line with a characteri...

A: Given, Load impedance (ZL) = 100 ohm Characteristic impedance (Zo) = 50 ohm Frequency = 10 GHz  

Q: 4. A step-down transformer is used to change 220 to 12 V. If a resistive load consuming 3 connected ...

A:

Q: Transposition of transmission line is done to А. balance the line voltage drop В. reduce the corona ...

A: Transposing is changing of position of transmission line in periodic form for reducing voltage unbal...

Q: Primary current in a current transformer is determined by Group of answer choices The load on its o...

A:

Q: equipment used to combine and level-match a multiplicity of electronic signals as from microphones, ...

A:

Q: Q5. For a PNP Bipolar Junction Transistor base-emitter voltage, VBE is 0.7 V at collector current, I...

A: We need to find out the base , emitter current and saturation current.

Q: is the time interval required for the particle to go through one full cycle of its motion. it's the ...

A: The message signals have less frequency. With this less frequency, it is not possible for the messag...

Q: Using 10v dc source to produce 8 mA to feed circuit, so calculate the value of all resistors.

A:

Q: 11. Obtain the node voltages from the circuit shown below: 5 k2 10 V 20 V V2 +) V3 4 mA 12 V 10 k2

A:

Q: 4-5 Compute the following if Voltage supply is 143 Volts <3. A. total capacitance B. total charge 4....

A:

Q: For the circuit shown below; find: 1. V (Input Transition Voltage) 2. V. (Output Transition Voltage)...

A:

Q: A pulse radar system has the following specifications/parameters: PT=100 kW ; Receiver sensitivity=1...

A: Given parameters: PT=1000KWReceiver Sensitivity=1μWσ=1 m2fc=1 GHzςp=2KHz   First we will calculate t...

Q: Explain the working principle of Forward-Reverse, Start-Stop and Jog Motor control with your unique ...

A: Motor-  A device which converts electrical energy into mechanical energy. The speed of motor is cont...

Q: Question No. 2: Let z1 = 2 + j2 and z2 = -2 + j6. (a) Compute the polar form of z1 and z2. (b) Compu...

A: Since you have posted a question with multiple sub parts , we will solve first three sub parts for y...

Q: + Vcc = 20 V R, = 18 kn Rc = 1 kl Cout Bac = 200 R= 1.5 k Vn = 25 mVpp RE = 240 N R = 2.7 kN CE

A:

Q: 1. The electric voltage, V(t) = 150 + 75 sin(20nt) [mV], is going to be observed on the oscilloscope...

A:

Q: 40 From the finite to the infinite matrix elements. We have ac, + Bez = Ec, (for p = 1) Bc, + ac, + ...

A: Note : Student just asked to explain how to get 3.10 . So I explained that part. Go through below pa...

Q: In the circuit of Fig. 13.24, calculate the input impedance and current I1. Take Z = 60 - j100 N, Z2...

A:

Q: How many lines are there in an NTSC signal?

A: In this case, out of the given options, the correct option corresponding to the number of lines pres...

Q: For the fixed-bias configuration, determine: a. Base Current b. Collector Current c. Collector-Em...

A: Given: The following circuit diagram of the fixed bias circuit is given:  

Q: Given A= 20260°, B-2+j2, C=4+ j3 and D=5230°. Calculate the expression for AB (C+D) in rectangular f...

A:

Q: Using the circuit in Figure 24-27 on page 730 in the textbook, calculate the magnitude of the voltag...

A:

Q: B1 A single-phase, 50 Hz transformer has 30 primary turns and 420 secondary turns. The cross- sectio...

A:

Q: R(1) K( + 3) (s+ 4) (++ 1) (s + 2)

A: The given block-diagram is shown below:

Photoelectric

The photoelectric effect occurs when light (or similar incident radiation, including X-rays) falls on material together with a metal plate and causes it to emit electrons. The discovery of the photoelectric effect led to important new theories (and to a Nobel Prize for Albert Einstein). Photoelectric cells, or photocells, are utilized in burglar-alarm light detectors and garage-door openers (each employs a through-beam of light this is broken when something movements throughout it), and also to play soundtracks on film movies (in which a light beam shines through the soundtrack encoded at the film and is "read" with the aid of the photocells).