1. Predict the output from the following devices a) F = ? 0 MUX D 1 0 K c) 1 0 C=? 1 0 b) 0 DECODER ENCODER A=? B=7

Q: If reflection coefficient for voltage be 0.6, the voltage standing wave ratio (VSWR) is?

A: Given, Reflection coefficient, ρ=0.6

Q: Emitter Current is more than the collector current O always equal to base current less than the base…

A: Lets consider the NPN Bipolar junction transistor circuit,

Q: A transistor has ...... O one pn junction O 4 pn junctions O 3 pn junctions O2 pn junctions

A: There are two p-n junctions in the transistor. One junction is in between the emitter and the base…

Q: 4) When the transmission line is terminated by a matched load, what is the value of the VSWR?

A:

Q: Electrical Engineering Find the impulse response of a system with transfer function: 1 F(s) + s² + 1…

A: The solution is given below

Q: parallel plate capacitor has plates, each of area 80 cm2, separated by a distance of 5 cm. The…

A: We need to find out surface charge density of given capacitor

Q: Question No.84 Three loads, each of resistance 50 Q are connected in delta to a 400 V, 3-phase…

A:

Q: In a transistor if ß = 100 and collector current is 10 mA, then IE is ............ O 120 mA O 100 MA…

A: Given in a transistor, Current amplification factor of CB configuration, β=100 Collector current,…

Q: Q1/ Find VCE, VBE, and VCB in the circuit shown below: RB www 3.9 ΚΩ www Rc 180 Q Bpc = 50 +||+ Vcc…

A: We need to find out voltage for given circuit

Q: Diodes D1 and D2 are Silicon with forward voltages of 0.7 volts. vand vare the circuit's input and…

A: The diode conduct only during the forward bias and it will not conduct during reverse bias. During…

Q: A type K thermocouple with an 85 degree F reference produces a voltage of 52.48mV. What is the…

A: Here for K type thermocouple, we need to consider its Voltage Vs Temperature table.  Here I can't…

Q: A coil having inductance of 0.04 H is connected across 50 hertz AC supply. Calculate the inductive…

A: Given, A coil having Inductance, L = 0.04 H Frequency, f = 50 Hz

Q: Communication Fundamentals Second Year Homework 1 // AM transmitter has a total power (480kw) and…

A:

Q: For a non-uniformly doped semiconductor sample, the sheet- 1 resistance is given by: R =-…

A: Given , the sheet resistance for a non- uniformly doped semiconductor sample (Rsh). Also a graph of…

Q: 1. For the circuit below, determine the following: a) Ic and VCE 16 V 1510 ΚΩ Iso Ico • 1.8 ΚΩ Vc…

A:

Q: 5) If the amplitude of the carrier signal is 7V, and the modulation index m-0.8, find the amplitude…

A: In this question we need to find the amplitude of message signal Am

Q: ions and Applications: When resistors are connected in series in a circuit, w relationships between…

A: Given, We have a question. Please find the below attachment for the clear explanation.

Q: What is the phasor representation of I(t)=I∘cos(ωt) at half-period?

A:

Q: For an isotropic antenna in free space, the radiation intensity is 16 W /sr. How much power does…

A:

Q: A half-wave rectifier is needed to supply 15-V dc to a load that draws an average current of 300 mA.…

A: Given, Half wave rectifier having Average load current, IL=300 mA Peak to peak ripple required,…

Q: H-w/ find the transfer function when G₂ X G₁ G3 Gs G4 (4) G6 y

A: In this question,   We need to determine the transfer function.  We are solving this problem using…

Q: BJT has a current gain Beta of 100.If base current is 2 μA,what is c collector current = 200 micro…

A: Given: A BJT has a current gain, β=100 Base current, IB=2 μA=2×10-6 A

Q: Q(1): Determine whether the system below is stable or not ? G(s) 240 (s+1)(s+2)(s+3)(s+4) R(s) E(s)…

A: Given data, Transfer function is given as, Gs=240s+1s+2s+3s+4

Q: Determine V, and I for each circuit in Fig. 2-5. Assume that each of the diodes in t circuits has a…

A: Solution

Q: Transients: What is the time constant of the following circuit in milliseconds? R₂ R4 UO Parameters:…

A: Given, R1=2 ΩR2=3 ΩR3=1 ΩR4=5 ΩL=2 mH

Q: With the aid of the electric circuit shown in figure 5, use superposition theorem to determine the…

A:

Q: 7. Given the following linear series voltage regulator calculate the minimum (VOMIN ) and maximum…

A: We need to find out the output voltage for given circuit .

Q: -8V P₁= 12kn m 22=2.5k-2 12V Si R3=5602 T Analyse the circuit using any. Circuit amatysis method to…

A: In this question we will find output voltage, diode current , diode voltage...

Q: 7) If the highest frequency of the baseband signal is 6 kHz, what is bandwidth of the DSBAM and SSB…

A:

Q: find capacitor voltage (calculate please) Let us compute the voltage across the capacitor for t20…

A:

Q: 10v 31. 32. I, R₁=40 I₁ = ? a. 308 mA b. 731 mA 1₂ = ? a. 308 mA b. 731 mA R,=6Ω 1, 1₂ R,=802 b U 4v…

A:

Q: When a lossless transmission line is terminated by a resistance equal to surge impedance, then what…

A: Given, A lossless transmission line is terminated by a resistance equal to surge impedance. Load…

Q: F 10 μF R₁ 12 ΚΩ R₂ 3.3 ΚΩ +1₁ Vcc +8 V Rc 330 Ω C3 HE 10 μF PDC = Bac = 150 V O out RE 100 Ω E 100…

A: Brief description : In the above given question they want to know overall voltage gain of the given…

Q: Example 8.16. A certain 3-phase equilateral transmission line has a total corona loss of 53 kW at…

A: The solution is given below

Q: Statistic question for signals please help. Let Z(t)=X(t)+Y(t), where X(t) and Y(t) are independent…

A:

Q: Q(1): Determine whether the system below is stable or not ? G(s) 240 (s+1)(s+2)(s+3) (s+4) R(s) E(s)…

A:

Q: A 50 Q distortionless transmission line has a capacitance of 10-¹⁰ F/m. What is the inductance per…

A:

Q: ransfer function and show that the high-frequency gain is (-R₂/R₁) and the 3-dB frequency co-1/CR₁.…

A:

Q: 1) find the Tf of DE K[n] Y [n] = 2x [n]+3x[n]-x [n-2) +17 x [1-3] - 6x[n-43 + Y [n-13-3Y [n-2]

A:

Q: The current 'i' and '12' in the circuit shown in Fig. is 100 • i, Ⓒ120 V 500|¹ 6A+

A: Given circuit,

Q: A certain BJT is to be operated with VCE = 5.7 V. If its maximum power rating is 105 mW, what is the…

A: We need to find out collector current for given power and voltage .

Q: 10. Calculate the current I for the network of Fig 20V = 1 mA 20° R₁ VR₂5 kn ΚΩ 2 ΚΩ FIG. 18.118…

A: We need to find out the current for given circuit.

Q: Q7. For each of the following baseband signals: i) m(t) = 2 cos(1000t) + cos(2000t); ii) m(t) =…

A: Solution

Q: In a transistor....... Ic = lE+IB IE= IC - IB E = IC + IB B = Ic+IE

A: Lets consider the NPN Bipolar junction transistor circuit,

Q: 2. Research on the following combinational circuit concepts. d. Latches e. Flip-Flops

A: Brief description : In the above given question they want to have a discussion on latches and flip…

Q: A telephone cable with R=52.5 KQ/Km, C=62 nF/Km, G=0 and L-1.1 mH/Km, find,x,ß,Vp and λ, length of…

A: Given a telephone cable with, Resistance, R=52.5 kΩkm Capacitance, C=62 nFkm Conductance, G=0…

Q: Q1): Find the T.F of DE (h[n]) Y[n]=2X[n] + 3X[n-1] - X[n-2] + 17X[n-3] - 6X[n-4] + Y[n-1] - 3Y[n-2]

A:

Q: By Nodal Analysis, determine the voltage V₂ of the circuit 252 jsn v m 8410A (1 Lin 452 jiori 2014…

A:

Q: The required number of bits to obtain a resolution of 0.625 V over a voltage range of 0 to 10 Vis 2…

A: Given, Resolution, R = 0.625 Voltage range of 0 to 10 V, Vm=10 V Number of bit required, n =?

Q: Find the Laplace transform of the following functions. (a) f(t)=sin (21) cos (21) (b) f(t)=cos (31)…

A: