1. Find the voltage between the open terminal A and B for the network shown in Figure-5 using Norton the rem and the value of R, is one half the value of R find the current through R. 4 A 15 Ohm 5 Ohm RL 10 Ohm -20 V 4 Ohm

1. Find the voltage between the open terminal A and B for the network shown in Figure-5 using Norton the rem and the value of R, is one half the value of R find the current through R. 4 A 15 Ohm 5 Ohm RL 10 Ohm -20 V 4 Ohm

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Related questions

Q: A B What is the resulting expression of X? Choices: a) (AB)' b) (A+B)' c) AB' + A'B d) AB + A'B' Y

A: Option d) AB+ A'B' is correct answer.

Q: Analog signals are in different from but a digital signal means only '0' or '1'. Only voltage among ...

A: A continuous signal that represents physical measurements is known as an analogue signal. Digital si...

Q: Solve for the total circuit impedance. Display your answer in rectangular form (R+-X ohms). With the...

Q: a. Find the equivalent capacitance. b. Find the voltage and charge on each C2 capacitor. C1 1 uF BAT...

Q: (c) If your system was a l170 W blender motor with a 120 V (60 Hz) supply and a power factor of 0.6 ...

A: The solution is given below

Q: In the unbalanced bridge circuit of the given figure, find the potential difference that exists acro...

A: Given: The unbalanced bridge circuit,

Q: A 4 -pole DC shunt generator with lap connected armature has field & armature resistance of 80Omega&...

A: Given: A 4 -pole DC shunt generator with lap connected armature has, Supply voltage, Vs=100 V Rated ...

Q: 34. Which of the following is not a technique for FM demodulation? a) Phase locked discriminator b) ...

A: In this case, from the given options, the technique which is not an FM demodulation technique needs ...

Q: • A coil connected in series with a resistance are supplied from a 240 volts 60 Hz source draw 1.0 a...

Q: 16. Sketeh vo for the claper Ckt. 20 C Ideal 5v 20

Q: Example-1: matrix form: 20 Ω -j5 2 ww V2 4/0° A V1 j10 2 60/30° V lll

Q: Da

Q: 2. A three-phase, three wire, CBA system with an a line voltage of 100 Volt, has three impedances of...

A: In this question three phase star connection is given....We have to find out line current , power fa...

Q: Compare the maximum conversion times of a 8-bit digital-ram p ADC and a 8-bit successive- approximat...

Q: Complete the pizza_calories_per_slice() function to compute the calories for a single slice of pizza...

A: 1. totalCalories= pizzaCalories(pizzaDiameter); Explanation: As mentioned in question pizzaCalories ...

Q: Implemen t a 6 bit R/2R ladder circuit and calculate Vout from the circuit. Calculate full scale...

A: Solve the problem

Q: Which of the following are used by scientist and electricians for ease of work? a. circuit diagrams...

A: The explanation is as follows.

Q: 3. Find current I in the circuit below. 100 0 400 0 200 0 6 v 1000

Q: Initial conditions for the circuit below: switch is open and capacitor is uncharged. Determine the i...

A: GIVEN: R1=4ΩR2=4ΩR3=5ΩR4=3ΩV=10V FIND: initial and steady state current through ea...

Q: I-V curve of a hypothetical piecewise linear device is given below. 个工() 2+X Here, x = 03 1. What ar...

A: As per the guidelines, we can only provide the solution of first three questions in multiparty type ...

Q: Q1 (a) Based on electrical DC circuit as depicted in Figure Q1(a), (i) Determine the mesh currents I...

Q: In a half wave rectifier, the input sine wave is 300 sin 100 TTt Volts. The average output voltage i...

Q: A PMMC instrument with a 200 turn coil has magnetic flux density in its air gaps of B=1.2T. The coil...

A: We are given: N= 200 turns, B= 1.2T, D= 2cm or r= 1cm, L= 2.5cm, I =2mA. We need to find Td.

Q: 2. Solve for I.

Q: Q2 (a) Based on the relationship between the line and phase value of currents and voltage, show that...

A: the solution is given below

Q: A PMMC instrument with a 200 turn coil has magnetic flux density in its air gaps of B=1.2T. The coil...

A: Given: A PMMC instrument with, Number of turns, N = 200 turns Flux density in the air gap, B = 1.20...

Q: The force between two charges is 200 N. If the distance between the charges is doubled, the force wi...

A: Given: The force between two charges is, F = 200 N Let the distance between two charge is r If the d...

Q: For an 8-PSK system operating at an information rate of 36 kbps determine, 1. Baud 2. Minimum ban...

A: The solution is given below

Q: A 1 mA ammeter has a resistance of 100 Q. It is to be converted ti a 1A ammeter. The value of shunt ...

A: Given: Meter resistance, Rm=100 Ω Current through ammeter, Im=1 mA Extended current, I = 1 A

Q: 20: Given ddc=0.98 , determine Bac O Given Pdc=120 , determine the coriesponding valve of d. Te=2:0m...

A: Part (a) - Given that,αdc = 0.98We know,The expression for β is givem by,β=α1-α --(A)

Q: A 50-W 22-k ohms resistor, a 100-W 82k ohms resistor, and a 150-W 36 k ohms resistor are connected i...

Q: Question -10 A PMMC instruments has a coil of dimensions 12 mm × 10 mm. The flux density in the air ...

A: In this question , PMMC instrument is given with current , coil dimension , no of turns and current ...

Q: Q1 * UTM UTMA) Based on electrical DC circuit as depicted in Figure Q1(a), 5 UTM UTM Determine the m...

Q: 42 () 2 H 16e'u(1)| 6 H 48(1)

Q: -9. Which of the following is true for first-generation wireless systems? ) Low rate -) Efficient ) ...

A: From the characteristics of a first generation wireless system, we can answer the above question. Co...

Q: When you are solving for circuit problems from the data obtained from experiments, what is the signi...

A: When you are solving for circuit problems from the data obtained from experiments, what is the signi...

Q: QUESTION 5 Correct the power factor for a motor connected in series with a 120V RMS 60HZ power suppl...

Q: 104 Fahrenheit converted to Celsius

Q: A unit step voltage u(t - 5) is applied to the R-L network below. The current is given by ww R = 10 ...

A: Given circuit,

Q: A PMMC instruments has a coil of dimensions 12 mm × 10 mm. The flux density in the air gap is 0.20 w...

Q: 10.7V 400 ohms 400 ohms 400 ohms 1.5V 400 ohms 400 ohms

Q: nominal vo ltage of 10.75V geven seference Temperature is B@ At what temperatere wile the lo-v zener...

Q: (a) (i) List categories of transformer. (ii) What are the losses that need to be considered when mod...

A: Transformer used to transfer energy from one device to another and it works on the faraday's law of ...

Q: D.02)

A: Given that ρ=2.8×10-8 Ωm l=20 m I=15 A Et=P<3 w We have to find the Cross section Area

Q: 20: Given ddc=0.98 , determine Bdc: Pac O Given determine the cormesponding Pdc =120 , value of c © ...

Q: You are working as an electrician in an industrial plant. You are given an AC oil-filled capacitor o...

Q: Electric Powers System for Nonelectrical Professional can you explain the purpose of capactictors, ...

Q: Find: 1. the unit vector directed from E towards F 2. the measure of all interior angles 3. the leng...

Q: Determine the diode cerent at 20°c for a siicon diode with n=2 , Is =0•14A at a reNerse potentral of...

Q: (b) Figure Q3(b) shows a magnetic circuit with two different material, with a mean cross- sectional ...

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

1. Find the voltage between the open terminal A and B for the network shown in Figure-5 using Norton the rem
and the value of R, is one half the value of R find the current through R.
4 A
15 Ohm
5 Ohm
10 Ohm
RL
-20 V
4 Ohm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the magnitude of the resistance R in ohms in the circuit shown in the opposite figure?! A- 2 B-4 C-8 D-12 ..
What is the voltage across the 50 Ohm and 5 Ohm resistors? Using the loop hole equation, what is the voltage across the R1? What is R1?
A secondary cell having an e.m.f. of 2V and an internal resistance of 1 ohm is connected in serieswith a primary cell having an e.m.f. of 1.5V and an internal resistance of 100 ohm. The negativeterminal of each cell is connected to the positive terminal of the other cell. A voltmeter having aresistance of 50 ohm is connected to measure the terminal voltage of the cells. Calculate the voltmeterreading and the current in each cell.
In the figure shown below, the current through loop 1 be 11 and through the loop 2 be 12, then the current flowing through the resistor R2 will be? RI R2 R3 O a. 1+12 O b. 1 O c. 1-12 12
The figure below shows three resistors (R- 13.5 0, R -7.95 0, and Ry- 12.5 0) and two batteries connected in a circuit. 40.0 V R 22.0 V R3 (a) What is the current in each of the resistors? A I2 = A A (b) How much power is delivered to each of the resistors? P1- P2- P3-
Two resistors RA and RB are connected in series across a 120-V source. When a 30,000-ohm voltmeter is connected across RA and then across RB, the instrument deflection is 48 volts in each case. What are the ohmic values of the resistors?
shfdjkfdrhnacoioeniodinopidopdnieocmixoxwmipdf.ziudSALIDUDetu The equivalent resistance of three resistors A, B and C connected in parallel is 1.5 ohms. If A is thrice of B and C is 1/4 of B. Find the equivalent resistance when the three of them are connected in series? dhffrriru9ee
What Rx in parallel with 40 ohm will provide and Req of 24 ohm?
Calculate values of asked physical quantities of the circuit: The circuits terminal voltage is 16.7V and then resistors A&B are in parallel. The resistance of resistor A, is 6.2 ohm and for B it's 7.9 ohm. What's the current going through each resistor?
A 20-ohm resistor is connected in parallel with a variable resistor R. The parallel combination is then connected in series with a 4-ohm resistor and connected across a 240 V source. Determine the minimum value of Rif the power of R is equal to the power taken by the 4-ohm resistor.
A 120-A current flows into two parallel resistors having resistances of 15-ohm and 28-ohm. Find the current in the 15-ohm resistor. Round your answer to 2 decimal places.
In the figure below, what is the potential difference Va-V, between points d and c if %₁-5.0 V. 82- 1.8 V. R₁ R₂ = 140, and R3-5.2 Q, and the batteries are ideal? Number i -11341 Units V #1*