Answered: 1. Compare the power in watts with the…

1. Compare the power in watts with the apparent power in volt-amperes for the following apparatus in AC circuits : (a) Electrical lamp, (b) choke coils and (c) capacitor.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 2RQ: What is the advantage of alternating current over direct current?

See similar textbooks

Related questions

Q: 2. Find IB, IC, IE, VCE and VCB for the common emitter configuration of a PNP transistor. Rc 390 Ω…

Q: G₁ The components of the power system shown at right have the following characteristics. OPHO T33 M₁…

A: Power is an electrical network consisting of three stages generation, distribution, and transmission…

Q: tain the state model in U(s)- form of S+3 s(s+ 10) system shown 24 (s+8) 4 (s+1) figure. Ans. : X =…

Q: Determine the input impedance, Z, in rectangular (Cartesian) form if = 5 rad/s. Zn → 2 ΚΩ 20 H 2 mF…

Q: 1. Zener and Avalanche breakdown

A: Ans.(1) Given: Zener and Avalanche breakdown

Q: Low-pass filter Bandpass filter High-pass filter Amplifier Amplifier Amplifier Summing amplifier…

A: The filters in a digital communication system are used as a circuit to get the output in desired…

Q: The one-line diagram of a 3-bus system is shown. The regulating transformer RT with a ratio…

A: Bus admittance matrix: It is a matrix formed by the admittances. These admittances are of nodal…

Q: 3-phase IM has a slip of 5% and a full load current of 16A. The rotor is connected in star and the…

A: In this question we will find rotor power loss in induction motor....

Q: 1. Using exact analysis, find VTH, RTH, IB, IC and VCE for a voltage divider bias configuration of…

A: In this question, We need to calculate the VTh RTh IB IC and VCE for a voltage divider bias…

Q: in the circuit shown below, the current flowing through the two loads = 10 A (rms). The load Z₁…

Q: Find IB, IC, IE, VCE and VCB for the common emitter configuration of a PNP transistor.

Q: 1. How many 16 K memories can be placed (without overlapping) in the memory space of a processor…

A: In this question we will write about memories placed in processor with given address lines.... Note…

Q: Hw/find the transfer function when in matlab G₁ = 1 S S , G₁ = √3+2 , G2 = G3 1 S +1 5² +2 Hi= H₂ =…

Q: #3 With the aid of a well labelled diagram, explain the stages involved in a bathtub curve

A: Bathtub curve: A bathtub Curve is for the most part a diagram that is utilized to exhibit a…

Q: USING NODAL ANALYSIS SOLVE THE CURRENT THROUGH EACH IMPEDANCES. Z1 22 23 Z5 V2 V1 Z1 = 1+j2 Z2 =…

A: In this question, a circuit is given We need to determine the current in the each Impedance using…

Q: 1. Using exact analysis, find VTH, RTH, IB, IC and VCE for a voltage divider bias configuration of…

A: Brief description : In the above given question they have mentioned a common emitter amplifier…

Q: Draw the energy band diagram of a n-type semiconductor

Q: A power transistor is specified to have a maximum junction temperature of 150°C. When the device is…

Q: A 500V, single-phase SM gives a net output mechanical power of 7.46 kW and operates at 0.9 pf lag.…

Q: 6. A 50 hp, 550 volts shunt wound motor draws a line current of 4.5 Amp at no load. The shunt field…

A: In this question we need to find a efficiency and total loss of motor at full load

Q: Draw the equivalent circuit and characteristic curve of a forward biased diode using the first or…

A: To draw the equivalent circuit and characteristic curve of an ideal diode model.

Q: Below is an example of an NMOS logic circuit. For all of the MOSFETs in the circuit below, assume V…

Q: As a final step in the design process, the output stage of a radio amplifier must be matched to the…

A: This question is related to impedance matching of transformer

Q: Is the following 0 6 A= 1 0 01 system BIBO stable? Is it internally stable? why? 9 0 FB-₁0-10 B= C=…

Q: In own words, elaborate and explain the difference between capacitor and resistor in terms of…

Q: simplify its block diagram. with mathematical equation

Q: Consider the following circuit below, assume V₁ = 1.2 V and k = 0.5 mA/V². th a. Determine I (in…

Q: Determine the d.c. resistance of a diode at V=-20V if its reverse saturation current is 1 μA. (Take…

Q: 2. For a system,the input signal is r(t)-1-e* and the output is c(t)-1-et the transfer function will…

Q: "Modern complex systems are more pronounced with closed loop control system".Justify the statement .

A: Control systems: A control system is a collection of equipment that controls, orders, directs, or…

Q: 1- Frequency response describes the (a) Transient response (b) Steady state response (c) Transient…

A: We need to select correct option for given statement .

Q: Draw the equivalent circuit and characteristic curve of a forward biased diode using the second or…

A: In this question, We need to determine the Draw the equivalent circuit. The characteristic curve of…

Q: Example 2.5: Obtain state model by direct decomposition method of a system whose transfer function…

Q: 12.75 Use voltage division twice to find V in the circuit shown in Fig. 12-31. Ans. 81.2/6.04 V -j20…

Q: 11. A parallel plate capacitor has the following values k=81, d=0.025 inches, A= 6 square inches.…

Q: Example15/ 1)T-L with ZR=50+j100 2 and Zo= 500 find ZRn 2)T-L with ZR =100+ j75 2 and Zo =502, find…

Q: Determine the input impedance, Z, in rectangular (Cartesian) form if = 5 rad/s → 2 ΚΩ 20 H 2 mF 'in

Q: 1. Determine the input-output equation and the frequency response in Fourier transform of the given…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: 5V B OV OV For all the MOSFETS assume Vth=1V and k =50 mA/V² R₁ = 4700 Ao M₁ M₂ B Indicate and…

Q: 9. Draw the equivalent circuit and characteristic curve of a forward biased diode using the second…

A: To draw the equivalent circuit and characteristic equation of ideal diode model.

Q: Find each capacitor voltage in the circuit shown in Fig. 8-9. 20 μF 30 μF HE V₂ 40 μF 400 V + ₂9 F…

Q: A power transistor is specified junction temperature of 150°C.

A: Ambient temperature- It is a atmospheric or environmental temperature of any object or device when…

Q: Find Beta if Vce = 6V. * Vcc= 12V 470 k Ohm 1.5 k 0hm 8 -w 1 kOhm

A: The solution is given below

Q: H.W. In the network in Figure shown below, V, is known to be 8 45°V. Compute Vs: 13 2Ω -j2 Ω ΣΖΩ 1₂2…

A: given here a circuit and asked to find the Vs when the output voltage is V0 = 8∠45° V

Q: A coil has a resistance of 75 ohms and an inductance of 1.4H. When the applied voltage is 240V, at…

Q: full detail with drawing/graph Three balanced impedances ZA = ZB = ZC = 19.01 + j11Ω are connected…

A: Phase voltage and line voltage in delta connected system remain same Phase current and line current…

Q: An induction motor, 3phase, 60 hertz, 6-pole, 352 V, has a stator connected in delta and rotor in Y.…

Q: Determine the built-in potential of a Au-Si contact if the Au workfunction is 5.1 eV and the Si is…

A: We need to find out built in potential for given system .

Q: Tw 21 = 50kΩ -5V V². d Vos(in V), and the MOSFET? Verify your answer. +1₁ * R3 = 4.7kΩ

Q: For an ideal MOS structure with a fixed oxide charge density of 10¹0 cm-² on an n-type Si substrate…

A: Given data, Oxide charge density =1010 cm-2 Electron doping is given Nd=1017 cm-3

Question

ANSWER COMPLETELY WITH CLEAR SOLUTIONS

1. Compare the power in watts with the apparent power in volt-amperes for the following
apparatus in AC circuits :
(a) Electrical lamp, (b) choke coils and (c) capacitor.
121

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An alternating current was measured by a DC milliammeter in conjunction with afull-wave rectifier. The reading on the milliammeter was 7.0 mA. Assuming thewaveform of the alternating current to be sinusoidal, calculate: (a) the r.m.s. valueand (b) the maximum value for the alternating current.
Each terminal of a small polarity-independent incandescent bulb is connected to the positive terminals of two (2) DC voltage sources. The negative terminals of these sources are connected together. The first voltage source can have a range of value from 0-12, incrementable by 1.5 volts every turn of the rotary switch (i.e. 0 V, 1.5 V, 3 V, 4.5 V .... 12 V). The voltage of the second source is unknown. Using a luxmeter, the brightness of the lamp was measured for every increment of voltage of the first source. The following observations were recorded: a. 1.5 V produces a higher brightness than 3 V b. 0 V produces a higher brightness than 1.5 V c. 12 V produces higher brightness than 9 V d. 12 V produces equal brightness as 3 V What is the voltage of the second source? Justify each observation.
Discuss the difference between Alternating Current (AC) and Direct Current (DC)
Answer the question briefly. 1. What is Alternating Current (AC)? Draw a simple graphical representation of AC. 2. What are the advantages of using alternating current over direct current?
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158 volts, 50 Hz supplies the combination. Determine the following: a. Circulating current b. Voltage across the resistor c. Voltage across the capacitor
DC-AC Circuits Approximately, how long does it take the circuit to have a current near 5A upon closing of the switch? 5V 5H O A. 25 seconds B. 5 seconds O C. 1 second D. O second O E. 0.2 seconds
Could you slove this dc electrical circuit
Describe the characteristic and operation of the meter movement in measuring alternating-current. Provide illustrations.
Which of the following is NOT a variable in voltametric methods? A. How the current is applied B. How the potential is applied C. The inclusion of convection D. All the above E. Type of working electrode
Figure (El1) 12- For the electric circuit shown in the figure (E12), determine the value unar of (R) if the current trough the branch AB is zero and the total current is 1A. Note that all the values of resistors are in ohm. 1.5 B. R 10V Figure (E12) d by
1- A). Which of the following could be used as a discharge device in an inductive AC circuit? a) resistor b) diode c) metal oxide varistor d) "a" and "c", not "b" B. What is the purpose of a discharge device used in conjunction with opening a highly inductive circuit? a) to minimize the possibility of damage to the circuits insulation as a result of a high induced voltage b) to minimize the possibility of endangering the life of the person opening the controlling switch c) to allow the magnetic field to gradually collapse, thus limiting the value of the self-induced ernf d) all of the above C. The high voltage induced by an inductor when its circuit is opened could be used constructively for a) an automotive ignition system b) an electric fence c) both "a" and "b" d) neither "a" nor "b"
State the relationships of total and individual electric potentials in (a) series circuit. (b) Parallel circuit.