1. An AC generator has 85 rectangular loops on its armature. Each loop is 11 cm long and 8 cm wide. The armature rotates at 1500 rpm about an axis parallel to the long side. If the loop rotates in a uniform magnetic field of 0.8 T, which is perpendicular to the axis of rotation, what will be the maximum output voltage of this generator? Volts

1. An AC generator has 85 rectangular loops on its armature. Each loop is 11 cm long and 8 cm wide. The armature rotates at 1500 rpm about an axis parallel to the long side. If the loop rotates in a uniform magnetic field of 0.8 T, which is perpendicular to the axis of rotation, what will be the maximum output voltage of this generator? Volts

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 36PE: A 75-turn, 10.0 cm diameter coil rotates at an angular velocity of 8.00 radius in a 1.25 T field,...

See similar textbooks

Similar questions

The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
(a) A car generator turns at 400 rpm when 1he engine is idling. Its 300-turn, 5.00 by 8.00 cm rectangular coil rotates in an adjustable magnetic field 50 that it can produce suf?cient voltage even at low rpms. What is the field strength needed to produce a 24.0 V peak emf? (b) Discuss how this required field strength compares to those available in permanent and electromagnets.
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
A coil with a self-inductance of 3.0 H and a resistance of 100 2 carries a steady current of 2.0 A. (a) What is the energy stored in the magnetic field of the coil? (b) What is the energy per second dissipated in the resistance of the coil?
A 120-V, series-wound dc motor draws 0.50 A from its power source when operating at full speed, and it draws 2.0 A when it starts. The resistance of the armature coils is 10 , (a) What is the resistance of the field coils? (b) What is tire back emf of the motor when it is running at full speed? (c) The motor operates at a different speed and draws 1.0 A from the source. What is the back emf in this case?
The healing coils in a hair dryer are 0.800 cm in diameter, have a combined length of 1.00 m, and a total of 400 turns. (a) What is their total self-inductance assuming they act like a single solenoid? (b) How much energy is stored in them when 6.00 A flows? (c) What average emf opposes shutting them off if this is done in 5.00 ms (one-fourth at a cycle for 50 Hz AC)?
A solenoid 50 cm long is wound with 500 turns of wire. The cross-sectional area of the coil is 2.0 cm2. What is the self-inductance of the solenoid?
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
A generator spinning at a rate of 1.20 103 rev/min produces a maximum emf of 45.0 V. At what angular speed does this generator produce a maximum emf of 64.0 V?
A car generator turns at 390 rpm when the engine is idling. Its 296-turn, 5.04 cm by 7.99 cm rectangular coil rotates in an adjustable magnetic field so that it can produce sufficient voltage even at low rpms. What is the field strength needed to produce a 24.4 V peak emf? T
A generator has a 46-turn coil with an area of 0.07 m2 that turns at 25.0 rad/s in a 0.48 T magnetic field. What is the current through the coil when the normal to the coil makes an angle of 30o with the magnetic field? The resistance in the coil is 7.84 Ohms. Give your answer in Amperes.
At what velocity (in revolutions per minute) will the peak voltage of a generator be 490 V, if its 490 turn, 8.00 cm diameter coil rotates in a 0.250 T field? 795.77 X rpm